DropnDuctor V3 5015 ender3 with ADXL mount

thingiverse

the original file had no openings for the fan intake. I've opened that up and added an ADXL mounting point as well ( from https://www.thingiverse.com/thing:4977191 ). Also added an extra screwhole that matched up with the holes in the 4020 design. Haven't printed yet, will update afterwards. --- EDIT --- ( V2 ) After printing I found out that my bltouch clone wouldn't fit right and I did not know how to fasten the screws with this design. I moved the holes for the bltouch a bit up and removed the large space underneath it so you can tightening it down with bolts. -- EDIT 2 --- ( V3 ) - Could not fit my 5015s in nicely, opened up some space so the cables can go through. - also opened up some space for bltouch cables - removed the useless hole, was in the wrong place. - added an extra mounting hole around the right wheel. Remixed from https://www.thingiverse.com/thing:4935492 - removed ADXL bulge and added mounting holes near the radial fan / bltouch for a cleaner look -- EDIT 3 --- the 5015 fans do NOT have a tight seal. This model is not usable until that's fixed -- EDIT 4 -- removed the older models as it would be a waste of your time to print them. - remodelled inside of the fan holders so there is a tight seal - added extra cable route - moved the middle part (with the bltouch and axial fan) closer to the hotend so there is less of a gap there. - lowered the bltouch mounting hole. If it's to low for your genuine bltouch just add some spacers probably going to redo the whole fan holder part as the air stream is not very focused.