drop side container (open and closed) Automatic locking

grabcad

brief operational description (without any need for completeness)Due to the increase in the size of the hot materials, the previously used container was no longer suitable for long-term cooling, as the blanket layer no longer covered it properly, and as a result, the cooling time was faster than expectedAfter several months of thinking, I was able to start the design, as there were a lot of technological and geometrical parameters that had to be met:I. General RequirementsThe container must be equipped with a specific systemThe container must be designed for storage of approximately 2000 unitsThe container must be adaptable to specific storage conditionsII. Handling and TransportationContainers must be stored on railsContainers must be able to be moved using a trolley and craneContainers must be easily accessible during loading and unloadingIII. Functional RequirementsThe container must have both storage and loading/unloading functionsThe container must be able to be quickly closedThe container must be designed for use in high-temperature environmentsThe container must be resistant to heat stress and thermal shockThe container must be able to be walked around during fillingThe container must not require maintenanceThe container must be stackableIV. Safety and ErgonomicsThe container design must ensure good ergonomics and prevent finger pinchingThe door must not be too heavyThe container must meet work safety requirementsV. Common RequirementsThe container design must prioritize simplicity and cost-effectivenessWhere possible, the container component should perform multiple functionsVI. Universal ApplicationThe container design must prioritize universal application, with each container equipped with the same systemEach container must be equipped with the same systemVII. Additional RequirementsThe container design must minimize the need for excessive modificationsThe container design must ensure compliance with work safety requirements