Drop Ceiling Camera Mount

thingiverse

**This is a WIP** Cura shows an error due to internal faces. I'm not done editing this yet so I'm not ready to purge the extra faces. Please print at .12mm with supports. If your printer is not perfectly calibrated, the threads will not fit. I needed to mount a camera from my basement ceiling. I found clips and mounts and ball joints but not what I needed. So, I combined all three. I've printed this once and it functions, but I'm still fine tuning it. Posted because I will probably forget to post it later, but I figure it's useful. Print at maximum .14 mm layer height. I used .12 Super Quality on my Ender 3 Pro. It seems to barely hold my 300g camera, so use with caution TO DO: Make socket smaller for tighter fit Make clip bigger (hold heavier loads) Test in PETG (heavier loads)