Drone

thingiverse

Installing printed motor mounts and arms, preparing to install glass and heat bed prior to printing body. Comments, ideas, thoughts are greatly appreciated. V2.9 Updates: Arms printed well but worry that slant bridge design in same direction allows for too much flex. When BangGood parts arrive, will use // support design until they break before switching to X support. Motor mounts printed strong and sturdy although Slic3r's support material was quite difficult, actually broke first set when removing supports. V2.7 Updates: Side walls were too small to incorporate FPV camera later, also seeking thoughts on "Battery Cage". Fear it will add unnecessary weight. Considering adding velcro straps by slotting holes in bed instead. 375mm tip to tip. M3x bolts for electronics. M4x16mm Bolts. Working on effective universal bracket to mount battery.