Drone Model - simple small

thingiverse

I designed a basic print, no assembly drone that could be built and flown within a LEGO model. This design was intended to be printed as a small square, about a few inches in size. It's a straightforward model but suitable for use in smaller models or as part of a Lego-sized simulation. When printing this model, I found that switching colors around 82% gives the body a nice, vibrant color while leaving the blades and housing black. If you don't switch colors, a quick coat of fingernail polish can be applied for a paint job. To balance the drone in flight, place the fishing line along the spine of its body. As seen in the middle photo, I left some glue on there. The Fusion360 model is included for your reference.