Drok Adjustable USB Load Case

thingiverse

This is a simple box designed to house a DROK variable USB load device. It's not fancy, but it gets the job done. I bought the device on Amazon from this page: https://www.amazon.com/gp/product/B016EYMVX4 Printer Settings: * Printer: QiDi * Rafts: No * Supports: Yes * Resolution: I used 0.2 mm per layer with MG PLA filament. * Infill: It doesn't matter, as the walls are only 1 mm thick. Notes: I used 5 layers on top, bottom, and outside to ensure it would fit snugly inside the box. Post-Printing: This was a quick and dirty design job. If I had taken more time, I could have designed an angled roof section instead of a 90-degree roof next to the fan, which might have printed without supports. That would have saved me a lot of time spent removing interior supports after printing. Next time, I'll do it differently. To assemble the device, remove the supports, take off the two knobs, angle the device into the box, and put the knobs back on. Since it's a tight fit, I didn't attach anything to secure it inside the box. However, I did add some double-sided foam tape under the USB connector to hold it in place. Custom Section: If you want to make changes, feel free to do so! This design was created using Tinkercad and can be edited online at: https://www.tinkercad.com/things/b0Z1aXg4Wy0