Drinking Glass

thingiverse

Spiral-Shaped Water Glass Created with T-glase Filament and Single Shell Corkscrew Printing Technique. Perfectly Fitting in Hand, Attractive Interference Finish, Lightweight but Fully Water-Proof. Material Cost is Approximately 0.5€. **Operating Instructions** There are Two Available Models - One Open Surface and One Solid Object Design. The Open Surface Functions Successfully in Simplify3D Software; However, Compatibility with Other Slicing Programs May Vary. In Case of Trouble, Try the Solid Model and Cancel the Print Before Upper Surface Filling Initiates. Successfully Tested with Wanhao Duplicator 4x and 1.75mm T-glase Filament on a Glass Plate with Painter's Tape. Print Parameters: * Layer Height: 0.37mm * Bottom Layers: 3 * Shell Design: Single Corkscrew Vase Mode * Temperature Settings: + Extruder: 235C + Bed: 80C * Printing Speed: 650mm/min * Extrusion Multiplier: 1.15 * Extruded Material Width: 0.5mm