Drill Tap Set holder (wall mount)

thingiverse

Thanks to nearxos for the design. I added a small support to the bottom so the bits wouldn't fall through (although it's a tight fit so they shouldn't). I used a bar instead of making it solid so if anything small falls into the holes it will fall through. I added two screw mounts on the sides so I could put the holder on the wall. I relabeled one for Imperial units. Also, there are two versions of each. The two screw mounts on the sides require supports (if you print in the orientation of the holes up). I'm not a fan of supports so I made a second version of each called "...with supports". These versions have small disks on the bottom that will serve as supports and then just easily twist off after printing. You can see the supports I made in the attached picture (I used a raft on that print also). Print settings I used are below, but they aren't crucial. Just use the settings that work for your machine. I hope you can find it useful!