Drill Guide for Mating Holes

prusaprinters

<p>You know the age old problem - You want to build a bed out of scaffold boards, but you are cack at the following:</p> <p>1) Measuring things;<br/> b) Using a drill;<br/> iii) Consistent lists.</p> <p>But you have a 3D printer...</p> <p>FEAR NOT, Stu has got your back. Hole Guide Part 1 is designed to use a 25mm flat blade to put a hole through a scaffold board, and then a 10mm drill bit to drill a hole in the end which goes through the middle of the 25mm hole.</p> <p>Part 2 is designed to fit over the end of a second board and let you drill a companion 10mm hole. All you then need to do is bolt it up, and you are halfway closer to not sleeping on a mattress on the floor.</p> <p>SCADs are included so you can remix them for any hole/wood you might have.</p> <h3>Print instructions</h3><p>I personally used 0.2mm and roughly 30% infill...but i'm certain that part isn't all too important. You will need to support the guides however.</p> <p>When I printed them, I oriented a flat side down. I'd suggest you do the same!</p>