Dremel Turbine

thingiverse

Transform your Dremel into a blower or vacuum; it works wonderfully well! The output port measures 0.75 inches in diameter and has an inlet of 2.15 inches. The inlet bolt circle diameter is 2.438 inches, fitting six 4-40 bolts. This creation was printed on a Fablicator from fablicator.com. Note: Be cautious when operating for the first time as the impeller tips spin at an incredible 200mph and may cause injury if not handled properly. Ensure a high quality print before use, and proceed at your own risk. Assemble the three pieces by attaching the neck to your Dremel snugly, followed by the impeller on the shaft (it might be tight but will fit with some effort). Make sure the impeller is completely threaded, leaving about 1/16 inch clearance from the bottom of the impeller and the neck. Be mindful not to break the blades while doing so. Lastly, attach the shroud, aligning the pins with the holes and securing it with six 4-40 x 0.25-inch screws. Enjoy your newly multi-functional Dremel!