Dremel router remixed hub with 18mm thread

myminifactory

I gave this useful design a fresh spin to match my Power Craft dremel clone perfectly. Unfortunately, the original design didn't quite cut it due to threads that were slightly too coarse, so I swapped them out in my version using Tinkercad with an 18mm dia 1.5mm pitch thread that now fits mine and possibly other Dremel clones just right. If you're unsure if it will fit, make a test piece first. Either sink the print into the bed until only 5mm or so is visible in the print area and print that part. Or flip the part upside down and cancel the print when you have 5mm left, then give the piece a test fit to avoid wasting filament altogether.