Dremel Drill Press Additional Features

thingiverse

Hello dear friends. Firstly, I created this design and it's extremely useful. https://www.thingiverse.com/thing:754248 But I adjusted a few designs to meet my needs. I have a dremel 3000 and modified "dremel3000 holder top and bottom." My bottom holder design securely holds the dremel in place for the nut. My top holder design is slightly wider than other versions, so I attached foam rubber bands to prevent scratches on the dremel case and minimize low vibrations from the drill machine. Secondly, I couldn't see the drilling area when working with this machine, so I added an LED light to the bottom holder. I fastened the LED light casing to the bottom holder using 2.5mm screws. I used five parallel-connected white LEDs and a single serial-connected 5 ohm resistor. For power, I employed an old notebook battery cell and charged it with the TP4056. Thank you again for designing this project. The design is very convenient.