Dremel 3D Idea builder spool adapter kit

thingiverse

This adapter kit lets you use various brands of filament spools with your Dremel 3D Idea Builder. The spool adapter was designed specifically for ProMolt 3D filament spools, but it should work just as well with other types. Installing the spool heightener can be a bit tricky. First, remove the six screws from underneath and disconnect the ground wire. There's also a ferrite ring attached to some cables by a zip tie, located right under the nuts. You'll need to cut this zip tie to move the ferrite out of the way. It seems they deliberately made it difficult to work on. To install the screw nut on the underside, you may need someone to hold it in place while you screw it from the other side. If needed, you can replace two shorter screws with M3x25mm screws, using the existing nuts. You can buy a package of these screws online for around $3.00.