Dreamcast controller fix for broken trigger pins

thingiverse

I recently acquired a used Dreamcast controller, but the triggers felt somewhat off. The triggers are held in place by a spring and pivot on two small plastic pins protruding from the sides of the trigger - these had cracked in my controller, rendering the triggers useless. This is my effort to repair them, a part that can be glued inside the hollow trigger in place of the broken pins. It's acceptable if the large pads don't print well, I found it difficult to get my slicer to print support underneath the pads so they printed without support. After cleaning up with a knife there is still a decent surface to glue to the inside of the trigger.