Dream Catcher and feather earrings

thingiverse

I really loved the dream catcher earrings made by OnePunchMan, but they were missing feathers, so I decided to print my own. I used the feather earrings from Vivenda as inspiration, but since I needed to shrink them down so small, there wasn't enough filament on the end to fit a jump ring through it. To fix this problem, I added a larger cylinder using Tinkercad. I printed more feathers than I actually needed just in case some of them broke or got damaged. The dream catcher itself is made from wood PLA filament and has a high level of detail due to its 0.1mm resolution and 100% infill. On the other hand, the feathers are made from bronze PLA filament. I used a lighter to heat up a sewing needle that was being held by pliers and then carefully pierced it through the end of each feather to make it easier to fit the jump ring through.