DRAWS Hat Raspberry Pi Case

thingiverse

Update: DRAWS Frame Pi4 and DRAWS Base Pi4 initial build for Pi4 B, DRAW Stop PP and DRAW STop, still fit. This includes a thin layer of the hole for power cable in the frame, which can be carefully drilled out. Update: DRAW Stop PP - this top plate supports the installation of Anderson Powerpoles. This is a very specific mod to support the nw-digital DRAWS Hat (June 2019). Note position of the SMA. The case is in three pieces. The base is mostly standard, I added a small cutout to see the power up and activity LED. I also added M3 threads for the outer screws and M2.5 threads for the inner screws and extended them all the way through (the original design had M3 here that was useless). The Frame section includes a hole above the Ethernet port. I use a simple M8 tap and then screw in a 2.1/5.5 power socket, which is soldered to the power cable. You could just pass the cable through here instead. I have added some vertical slits to improve airflow, but may need more. I currently use 35mm M3 screws to hold it all together. P.S. The walls are very thin and I print very fast so you can see the lines; doesn't matter - this is function over form. If you slice at .15 and run a bit slower, it's smooth.