Drawer Clamp For Desk

prusaprinters

This a drawer for under your desk that is supported by clamps. It has not been tested yet. What you want to do is print out the drawer with very low infill. Print the clamp with very high infill. you might need to sand/glue some of the pieces together. after printing put the 2 largest pieces and put the drawer part that hold items in the body of the drawer through the top. test if you can open and close. next put the the small pieces with the hole in the middle with the little slit is in the body of the drawer. then take the screw and put it in the clamp body. then move the drawer and the clamps to your desk and take the clamps and press them against the pieces with little holes in them. This for the clamp contest. Look at picture if you are confused.1* body of drawer1* drawer of drawer4* clamp of drawer4* screw for clamp4* mount for screw