Draw Dividers

thingiverse

I built these for a parts drawer I purchased from German retailer Hornbach. They are accessible through most of Europe with an EAN number of 4028354540184. Although it could be easily modified for another system, the exact drawer I have can be found [here](https://www.hornbach.se/shop/Sortimentskap-470x320x140-mm/962425/artikel-detaljer.html). Typically, you print one, two or three single dividers per draw, if you want to sub-divide the drawers use either the 2x2 or 3x2 along with one or two subdividers. Print 8-10 singles for an 8-hour print, or 4-5 subdivider setups (2x2 + one subdivider or 3x2 + two subdividers). Subdividers have notches on each part that mate together so holding up the parts that don't have any pre-made slots in the drawer. Using these combinations you can divide drawers up as follows. <pre> 2x3 + 2x subdividers |---|---|--- |---|---|--- |---|---|--- 2x2 + 1x subdivider |-----|----- |-----|----- |-----|----- 1x single |--------|-------- | | |--------|-------- 2x single |----|------|---- | | | |----|------|---- 3x single |----|---|---|---- | | | | |----|---|---|---- </pre>