Dramatic USB Button

prusaprinters

<p>Hi everyone!<br>This is a 3D-printed USB button I created a while back.<br>As many people asked for the files, I have decided to upload it here.<br>If you like this project, follow me on Instagram (<a href="https://www.instagram.com/do.robotics/">@do.robotics</a>).</p><p><strong>What do you need</strong></p><ul><li>1 x ATtiny85 development board</li><li>1 x Resistor (I'm using a 390ohm)</li><li>1 x SPST momentary push button (normally open)</li><li>1 x USB Extension Cable (desired length)</li><li>1 x 3mm screw - used to hold the female USB connector in place.</li><li>Soldering kit</li><li>Jumper wires</li></ul><p><strong>Assembly</strong><br>This should be straight forward with the provided images.<br>Some tips:</p><ul><li>Save some space by soldering the resistor directly to one leg of the resistor.</li><li>Solder the 3 ATtiny pins facing up, as can be seen in the picture.</li><li>Make sure to heat-shrink/wrap everywhere, to avoid shorts.</li></ul><p><strong>Code</strong><br><a href="https://github.com/dordchn/usb-button">https://github.com/dordchn/usb-button</a></p><p><strong>Important note</strong><br>This may be obvious, but I still want to clarify that building and using the button is at your own risk. However, I can testify that I built mine a few months back and It works perfect so far :)</p><p><br>&nbsp;</p>