Drain Strainer- 36mm diameter

thingiverse

This thing will create a decently fitting tub strainer with no mess if you use ABS at a 0.2mm layer height. To get the best result, make sure to secure that first layer. You can do this by moving your extruder slightly closer to the print bed and gently pushing it onto some soft blue-tape- covered ABS liquid. With an infill rate of 100%, it won't leak but since it's very thin, I sanded off a tiny bit on the edges so that you can easily clean the entire strainer. I altered this one myself based on the http://www.thingiverse.com/thing:279520 design, which was found through the Customizer tool (found here: http://www.thingiverse.com/apps/customizer/run?thing_id=279520) to be the starting point for this customization.