Dragon Head Filament Guide / PTFE Passthrough for IKEA Lack Enclosure

thingiverse

Have you wanted a sweet looking filament guide/pass through for your IKEA Lack enclosure, but came up short after hours of searching on Thingiverse? This filament guide was designed for you. Based on the original dragon design and ornament remix by cyclone (thanks for the awesome dragon design!), I created this filament pass through to accept and operate with 4mm PTFE tubing. It has a simple clip to keep the guide from popping out. All you need to do is drill through the Lack table top with a 3/8" drill bit (a very tiny bit of reaming needed), push the guide through, and secure it with the clip. I am planning to design a larger version that will accept two PTFE tubes at once, hopefully by the end of November, 2021.