Dragon Claw Feet for Tina2/Cadet

prusaprinters

This Will Need SupportsI needed to get my Tina2 off the table top to reduce the noise, but I wanted something a little more… “eccentric” than what I was able to find. I was originally going to just print a set of Rinoa's feet, but got inspired one night to check out tinkercad. After a few iterations I landed on this, which works, but still have LOTS of room for improvement, considering I hadn't even looked at tinkercad or any other 3D modeling software before this, that shouldn't be a surprise.  Firstly, I don't recommend using the balls, makes the unit extremely unstable, especially if you have a kg of filament mounted to the side of it. I also believe that while the balls reduced the noise significantly, it was a trade off as the printer itself vibrated more, affecting print quality.There is also something weird it does after printing the bowl the ball fits into, as though its trying to print an upside down pyramid or something. I don't believe it was my editing, but I could absolutely be wrong about that.TLDR: I stuck Rinoa's Tina2 foot on top of dethdeks Dragon Foot remix from thingiverse in tinkercad. Printed at 0.1mm in Eryone Bicolour matte Green and Purple filament on my Tina2