Dragon Ball Super Key Holder, GOKU

cults3d

Dragon Ball Super Key Holder with the image of GOKU, a beautiful design for all fans of the saga. The system is tested and works correctly as shown in the gif. For assembly follow the order of the images, it is recommended to assemble it without using glue to test the operation (especially the position of the guides), and then reassemble it and glue the corresponding parts. Assembly: 1- 0001.JPG, Insert the curved part of the vertical guide into the base and pull downward until it stops. 2- 0002.JPG, The gear is inserted into the cylindrical shaft of the base, the lower and upper guides are supported, as shown in the picture (see the number of teeth that support the gear of each guide). 3- 0003.JPG, The middle plate is inserted until it touches the base plate. flames are applied to the recesses of the lower and upper guides that are visible after the middle plate is in place. It is advisable to apply glue to the contact slots so that the KI flames do not slip out of place (remember to apply the glue only after testing the system and making sure that it is correctly positioned). 4- 0004.JPG, Apply the Guko image on the upper cylindrical shaft and the lower slit, glue can be used for fixing (remember to apply the glue only after testing the system and making sure that it is well positioned). 5- 0005.JPG, Add the hand on the cylindrical shaft of the right KI flame, glue can be used for fixing (remember to apply the glue only after testing the system and making sure that it is well positioned). to place the cover with the image of the Shenlong dragons, you have to use glue for fixing (remember to apply the glue only after having tested the system and made sure that it is well positioned). An important recommendation is to verify that the parts have been printed correctly without too many imperfections, otherwise remove burrs and roughness from the parts or increase the print quality.