Drag chain mount for a servo

thingiverse

I used two of these adaptors to mount drag chains to my Atomstack cutters' X & Y servo motors. I use a cable tie to clamp the ends close so its quick and easy to remove the drag chain when necessary. I also turned the servo 90degrees to minimise the height of the cutter in the enclosure and also make the cable run into the drag chain easier. Used drag chain purchased from Amazon. https://www.amazon.co.uk/gp/product/B01M0WRJ35/ref=ppx_yo_dt_b_asin_title_o07_s00?ie=UTF8&psc=1 The mounting block included in the files is to attach the X axis drag chain to the carriage on the Y axis. My Y axis chain is fastened to the base of my enclosure so didn't need a mounting print for that end. The stock cables on the Atomstack are too short to do this modification without soldering on additional length to all the cables, which is a shame as it would have been a simple task if there had been 200mm extra cable on each length.