Dr Doom Mask / Helmet

cults3d

This model prints out in one or two parts, and will fit perfectly on a 300mm x 300mm x 400mm printer bed (CR-10). A split-up version of the model is also available to suit smaller printers upon request. The dimensions can be easily found by taking a look at the pictures. The helmet itself stands about 271mm high and 167mm wide. The hole size measures approximately 160mm wide and 206mm long. Note that the hole located on the bottom of the helmet is too small to accommodate any person's head, which is why it comes in two parts: a front panel and a back panel. The back panel can be attached using either magnets or Velcro for added convenience. Alternatively, you could simply print out the front panel and use it as a mask instead. This fan-made representation has no affiliation with Marvel Comics whatsoever.