DoubleDecker

thingiverse

3D Printable R/C Double Decker. 63 Unique Parts, Some Requiring Multiples. Single Parts in Zip Archive. Print Settings: Printer: CraftBot PLUS Rafts: Not Necessary Supports: None Required Resolution: 0.2mm Infill: 3-10% Notes: The wing parts, including ailerons, were sliced with Slic3r at 100% infill and single shell. Other slicers caused double paths on each layer. All other parts feature single shell and 3 to 10% infill. A few parts require support. Fuselage: Verify infill matches bolt holes and motor mount. For gear, use 10% infill, two shells, and external concentric pattern. Wing connectors at the rear may need support; I achieved success without, but upper areas were imperfect. Some lower wing pieces present fitting issues; remove internal structure by tabs. Piece Count for Multiple Parts: 2 x Aileron1__LoW_UP 2 x Aileron1__LoW_UP_RH 2 x Stabilizer 2 x Stabilizer_tip 4 x Wheel 2 x Wing_bolt 14 x Fuselage Bolt Post-Printing: Assemble with CA glue. Flight Characteristics to be Reported After First Flight.