Double Stack for OWON DGE2070 and XDM1041

prusaprinters

I recently purchased the OWON DGE2070 Arbitrary Waveform Generator and the OWON XDM1041 Digital Multimeter. I wasn't sure where I was going to put them as my workbench is very small. After moving a few things around, I decided that, if I could stack them on top of each other, I would have enough space to put them next to my oscilloscope. I looked around and found a few different brackets for these devices, but nothing that met my requirements.So, I designed my own.It replaces the rear rubber feet on the devices with brackets designed to fit in the profiles for the rubber feet, letting them be stacked and secured to a desktop or shelf with screws to stop them from sliding around when in use. The Design also allows for the power and USB connections to be used without obstruction. It should also fit the other devices in this same form factor, but not guaranteed.I printed two of these brackets, on their sides with bed only tree supports, and they turned out great! Snug fit in the foot profiles on the devices and they solidly hold the devices.printed in Elegoo Rapid PLA+ at 0.2 mm layer height and 25% infill (because I forgot to lower it).I have included the .stl file as well as the .step file. Created using Fusion 360.