Double N20 Motor Mount

thingiverse

Double N20 Motor Mounts. 50mm x 20mm x 12mm units provide precise motor positioning. Approximately 60mm from wheel to wheel, allowing for easy alignment. Motors can be adjusted in and out by a few millimeters for optimal placement. Eight M2 countersunk bolts and nuts are required (at least four). Two optional M2 countersunk bolts or screws allow for secure attachment to the base. This design ensures accurate wheel alignment with a single mount. Individual motor mounts often struggle to achieve this level of precision. The internal countersunk holes on each mount enable easy installation. Mounting the motors on their sides helps maintain stability and balance. Without using the lid, these mounts can be installed top-down to reduce profile height. A switch or cables can be routed through the hole in the base for convenient access.