Double Mac Arch/Stand

prusaprinters

The original ( https://www.thingiverse.com/thing:2135190 ) was perfect for my Mac, a little loose but that was fine. After I received my iPad, I needed a place for it. So I thought why not a double arch. The original model was just doubled so that all proportions are included as in the original. I use it with a MacBook Pro 2016, it sits a little loose but it's easy to take out. The top opening is 18mm wide. At the widest point the arch is 39mm and in length 168mm. For the best quality I aligned it as it would stand and turned on the supports everywhere (PrusaSlicer 2.3.0). With a slice height of 0.20mm, my Ender 3 v2 took about 4 hours. If I put it on its side and also print with supports then I come to just under 2.5 hrs, but the quality suffers in my opinion. Infill always at 25% but that's up to you, you just shouldn't go below 15%. Have fun printing! Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: Doesn't Matter Supports: Yes Resolution: 0.20 Infill: 25 Filament: Sunlu PLA Grey Category: Office