Double j-head / E3D mount (for Orca or whatever..)

thingiverse

Update 2016-06-26 Beware, this is a work in progress. I've just discovered that this version will not fit into Orca v4x. I'll rework a 90-degree version that will fit. This mount attaches two J-heads or E3D hotends to a printer. It's derived from a regular J-head mount (as seen on Rostocks or Delta's). In my case, it's designed for mounting on my Orca v4x Be aware: This is the clamp for the J-head. Adjust your x-place accordingly. There are two versions - one long, derived from Delta plates, and a short version that fits between the x-rods of an Orca v3/v4. 09-02-2016 Slide plate published for the short version. I'll publish a revised Orca X-plate in the near future. Printer Settings: Printer: Orca v4x Rafts: Doesn't Matter Supports: No Resolution: 0.2mm Infill: 60% for strength and heat resistance Notes: ABS is recommended due to heat build-up above the E3D or J-head. Post-Printing Instructions: Push the J-heads without any bowden connector into the mount. Slide the plates for fixation. Some bolts are needed to connect everything to the x-carriage.