
Double Hirracane Prototype
thingiverse
UPDATE- Changes are made to the front sections and alignment panels for a better fit. ------------------------------------------------------------------------ Prototype files are available for a double-sided Hirracane blaster, with a warning that these parts are currently untested but should work in theory. All suggestions and recommendations for modifications are welcome if the fit or look isn't 100% perfect. Some parts need to be printed twice because they are two-sided: EDF Slider and EDF Holder. Screw holes are designed for M2 (preferably countersunk) screws (4-8mm), requiring 9 of them to complete the modification. To complete this mod, you'll also need: * 2x40mm EDF Shrouds from Hobbyking * 2x40mm EDF Fan blades from Hobbyking * 2 Brushed high-speed motors (Aftermarket flywheel motors will work) * 1 Zeus Blaster with Lipo mod * 27mm OD with 24-26mm ID PVC type pipe (Or similar) NOTE: Removal of the side tac rails is required for this to fit. NOTE: The lengths of pipe needed are currently unknown; if someone completes this mod and shares their results, it would be appreciated. NOTE: McMaster clear pipe is commonly used in Hirracane mods, but since that's not easily available in Australia, 20mm OD PVC from Bunnings was chosen instead; files can be modified later if necessary. ------------------------------------------------------------------------ Assembly instructions: Front section/s 1. Insert the PVC tube into the middle hole of the front alignment panel (length will be added after testing), and slide the panel into position in the Zeus feeder. 2. Assemble EDF fan units with motor and slide them into the EDF holder from the front, making sure the wires slip out of the built-in port (wire from blaster batteries and switches should already be done; a wiring diagram will come soon). 3. Solder/attach said wires to the EDF motor. 4. Attach the appropriate front assembly to the front alignment panel using screws. 5. Slip in the EDF slider (raised panel to the stock of the blaster). 6. Put glue in the EDF holder's holes and insert it onto the front assembly's posts. 7. Screw in the EDF grate on the front of the EDF holder. Rear assembly 1. Join the Lower and upper rear sections with glue followed by the top. 2. Slip the assembly into the rear of the Zeus Ammunition holder. 3. Insert the 2 sliders (left and right as labelled) into the assembly. 4. Slip on the rear assembly guide and screw it into the rear assembly. 5. Slide the inserted tube back into the guide. 6. Slide in the rest of the tubes. 7. Slide on the top rear sections as labelled and screw them in from the assembly guide.
With this file you will be able to print Double Hirracane Prototype with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Double Hirracane Prototype.