Double-Edged Razor Blade Handle

thingiverse

This is a remix of the EZ-Snap Razor Blade Handle by AdanA, adapted for classic double-edged (Gillette) safety razor blades that are only 0.1mm thick and prone to slipping under prints easily. You won't be able to lift any prints with such a blade except very small ones, but you can use the clearance to shove a thicker and larger blade or plastic sheet under the print and easily remove it from the platform. This also works well to remove skirts and any other small bits stuck to the platform. Be careful to keep the blade at a low angle to avoid digging it into softer build surfaces like BuildTak. Update 2016/08/07: A new version of the model has been uploaded, which features a larger tab that offers a more secure mount for the blade, allowing you to push harder on the blade without bending it. Update 2016/10/05: Another version of the model has been uploaded, which boasts an even larger tab and a slightly taller structure to hold the blade in place. This version has less risk of the blade slipping out when it gets caught under a print. Version 2 is still available for those who prefer the extra bit of flexibility in the razor blade. I recommend printing this at 0.1mm layer height to ensure that the subtle recess that prevents the blade from moving around comes out right and the tab to secure the blade fits correctly. If the tab would be too loose, add sheets of adhesive tape to its underside until it is snug. An optional cap is included; you can print this at any reasonable layer height. Be careful especially while mounting the blade, as those blades are very sharp. I recommend using the edge of a table to push the tab in the slot so you don't need to come near it with your fingers. Printer: FlashForge Creator Pro Rafts: No Supports: Doesn't Matter Resolution: 0.1mm Infill: 25%