double door (IKEA) Lack enclosure

cults3d

6/06/2017 added left hinge, handle and handle ends .OBJ file for those that want to edit it and use thicker perspex. Here is my take on the Lack Enclosure. I have used bits form other enclosures like the LEG JOINER and the Filament INTAKE TUBE so props to them. Please bare in mind mine is not finished as i don't have a lot of time to build it. It's made with 3 Ikea Lack tables this gives you just under a meter hight to work on your printer, and storage underneath( I will be putting perspex doors and sealing it too). LED's for lighting, seals and filtered ventilation are still in the pipeline, I will update this as I go. -----what you need----- 3mm screws 2mm wire (large paper clip) magnetic strip 2mm perspex 3mm MDF board ----notes---- - Print settings are in the pictures.(supports are only for the hinges everything should be printable as is. - You will need to cut grooves in to the perspex so you get a clean/ flush finish around the hinges and handles. - For left and right sides just print the mirror image along Y axis. - The hinges are held together with 2mm wire cut to length(large paper clip seen in picture) - The braces are screwed in with 3mm 12mm long wood screws. - The non- hinged gaps are 3mm thick so if you use board like me it needs to be 3mm but perspex will do to. - The hinge and handles are set for a 2mm thick perspex sheet, it's not to bad hardly flexes. - The lip of the handle is where you stick the magnetic strip that holds the doors shut firmly. - The handle is made of 3 parts the handle and handle parts x2 these are friction welded together. - To get extra hight to fit the printer in side i cut the fourth leg (that's not needed) in to 100mm tall sections (you can make them taller) then connected them to the base this is where you can use the LEG JOINER. - This is all made in mind that the PSU and Main Board will be located under the enclosure or behind.