Double Dabbing Dickbutt Zoetrope

myminifactory

A Zoetrope of the iconic reddit mascot "Dickbutt" executes a dazzling double-dab maneuver. View our captivating post on Imgur for videos at https://imgur.com/gallery/cmCYq51. The mounting system is engineered to accommodate a standard snap-locking DVD motor. It features bottom slots that allow light into the chamber, a characteristic of our Hex Strobe Docks and Wooden Strobe Docks. The design was then printed in Natural clear PLA to permit light to diffuse through the plastic from within. When creating a motorized strobe dock, you can also print it in colored plastic and illuminate it under white or colored strobe lights from above. Our Strobe Docks are available for purchase on our website at Novatropes.com. The sculpture should be rotated at approximately 500 RPM, with a strobe frequency of around 40 Hz and a duty cycle between 0.5% and 2%. Note that lower is better, but it will decrease brightness. RPM and frequency have not been recorded for this model, so experimentation will be necessary. Brightness can be increased by over-volting your LEDs, which is only safe at very low duty cycles (over-volting will burn out LEDs if left on for more than a second, so handle with care). Note: Mounting snap-hole dimensions are extremely precise. Print with a 0.4mm nozzle (only PLA has been tested but other plastics may be possible). Printing with a raft is also essential, as even slight bed leveling imperfections will result in the statue "wobbling" during operation and creating unpleasant visual noise.