Door with claw marks (for vaping, Deathwish Cthulhu mod)

prusaprinters

<p><strong>This is a backplate for the Deahwish Cthulhu Mod.</strong></p> <p>Besides the printed door you will need 4 magnets with 4mm diameter and 2mm length, plus a little super glue to attach them in the holes.</p> <p>It's printable on a FDM printer without supports, however I'd recommend to use a resin printer to keep all the detail.</p> <p>Before you glue the magnets into the door, make sure to put them in the correct way. Best is to put the magnets onto the magnets in the Deathwish mod and mark the side facing up with a permanent marker. The side with the marking is the one which is glued into the door.</p> <p><strong>NOTE: This is my own design and you are only allowed to print it for your personal use! I don't want you to sell the model or your prints of it! THANK YOU!</strong></p> <h3>Print instructions</h3><p><strong>NOTE: This is my own design and you are only allowed to print it for your personal use! I don't want you to sell the model or your prints of it! THANK YOU!</strong></p> <p>If you want to print in resin, I'd recommend to print on a raft with supports to keep the dimensions the best way possible. I printed it with 0.05 layer height and tilted it at an angle of 42° with supports on the bottom (this side will be inside the mod, so markings from supports will not be visible)</p>