Door hinge for Motedis 3030 B-Type extrusion

prusaprinters

<p>Door hinge made for Motedis 3030 B-Type aluminium extrusions.</p> <p>(or other frames that are 30mm wide)</p> <p>I wanted hinges that would attach the door flush against the frame. The only ones I had on hand or could source locally left a gap of a few mm so I made these as a temporary solution.</p> <p>I've been using them for a while now and so far no signs of wear and tear so I might just stick with them.</p> <p>Just to put it in perspective the door is 680mm high and 600mm wide and carries a 5mm acrylic sheet window. Not sure about the weight but it does weigh a bit.</p> <p>Specs:</p> <p>Width: 60mm</p> <p>Length: 75mm</p> <p>Height: 8.5mm</p> <p>Uses four 6mm screws and a 75x8mm dowel pin.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Prusa</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>i3 MK2S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20-25%</p></div> </p></p></p> Category: DIY