Door hands free handle fixture

pinshape

I was challenged to come up with a design that could fit full spherical or conical door handles so people can open doors without direct skin contact on their hands and use instead their forearm to open and pull doors. Especially during the tough COVID-19 situation, this could be seen as a good preventive action. I hope it can help all the community in general. Always remember you'll need a left and a right part to install on a complete door. Then just fix them with the back "horseshoe" piece. For fully cylindrical door handles, you will only need another type of "horseshoe" part also available from the files (Back_mount_2). This design will fit spherical handles with approximately 50 to 53mm in diameter and conical handles from 53 to 48 at their largest diameter. Full cylindrical ones can be fitted with diameters of around 50 to 53mm. For all designs with more than 51mm touching the inner surface of the 3D handle, you will need to cut the four small plastic center clips. Happy printing! Greetings from Portugal!