Doom 3 Plasma gun

thingiverse

**This prop is licensed under Creative Commons:** **Attribution-NonCommercial-ShareAlike 4.0 International (CC BY-NC-SA 4.0)** -Author of the original model (not printable, licensed under CC BY-NC-SA 4.0): Kotbfg -Changes made by EJBS91: I took the awesome "Plazmatron" model by Kotbfg, i edited it quickly to make it printable. --------------------------------------- **IMPORTANT DISCLAIMER:** -This printable prop is not perfect. Some of the smoothness of the original model was lost because of my fault. -It's a bit lengthy to print. Size is real life accurate: 74 cm Length -It's not super well suited for internal electronics, except for a couple led lights, and it'll probably need post processing and painting. -Despite the amount of pieces, it's easy to put together. -Some of the joints are airtight while others are a bit too loose so they need gluing or other way of keeping them together. ------------------------------------------------------- **OPTIONAL INSTRUCTIONS AND TIPS** -Some pieces are named x2 or x4, it means you have to print 2 or 4 of each of those. -About the pieces at the very front of the cannon which i called "needles", you'll notice they are too loose because the space between the "knobs" and the needle's rings is a bit too wide. (my solution was wrapping tape around the knobs before inserting them, that way the gape is reduced and it makes the needles stable, but mobile) -The small cables and some other small pieces have to be glued just by eye, since they do not have sockets to insert them. -Some joints are a bit too hard to push, you can sand paper them a bit until they fit better. -You can insert metal springs in the holes for the Trigger and for the display box, so they can be mobile parts. -Recommended to print the "screen display" and the "ammo cell top cap" with transparent material. -Any question or anything about this, message me, i'll reply asap. Thanks.