Donkey Chassis and Adapters - Current

thingiverse

This is the official edition of the Donkey Car, a project that offers extensive information at www.donkeycar.com. By default, it supports the Raspberry Pi, but also features an adapter for use with the NVIDIA Jetson Nano. The team extends special thanks to Doug LaRue and Jean Marie whose adapters served as a basis for this design. The Donkey Car supports the following vehicles: Magnet, Desert Monster, SCT, Blaze, and LaTrax Prerunner. This new version of the Donkey prints faster and assembles faster than its predecessor. However, it uses specialty hardware that can be challenging to find. It employs "Thread Forming Screws," also referred to as PT screws. The used sizes are: (3) 3mm diameter 10-12mm length for chassis (8) 2.2mm diameter and 6-8mm for Raspberry Pi and servo driver These screws can be found at specialty retailers or purchased in the Donkey store for $5 with shipping, available at https://squareup.com/store/donkeycar. The current F360 file is accessible at https://a360.co/2STUhf5.