Dollhouse Elevator Landing Steps & Limit Block

thingiverse

I wanted to limit the elevator decent to maintain floor level of 3rd story with elevator top. This caused a 60mm gap at the lower floor. The small stick has a bulge to "snap" into the sliding channel. It is also hollow to reduce material consumption. There is a hole at each end to use in case there is a need to extract. The base piece will simply sits in place. I am considering securing with thin layer of epoxy to bottom and wall side of base after sanding and some detail paint. Orientate base to print as it would sit normally in use (upright). I used triangle support at 10%-15% and 20% infill. Printed at 0.16mm quality. Approximately 26 hours