Doll bed headboard (for 12" doll)

thingiverse

I was searching for a bed for my daughter's 12" doll, which presented a challenge due to its length. A piece of plywood (9 cm wide) caught my eye as a suitable base and I decided to create two headboards that could be attached securely to the edges. To determine the best approach, I printed the design both upright and on its side. The results showed that laying it flat at a 90-degree angle required minimal support and produced higher quality prints. Frustrated with my online search for a similar model, I'm hoping this design will be helpful to others who may face the same challenge.