Dog water dispenser

thingiverse

The water bowl measures 100mm in diameter and is crafted from PLA, ensuring it's completely safe for consumption by pets. This design seamlessly fits within my dog's 3-foot cage, which boasts a standard vertical wire spacing of 34mm - a common dimension found in many cages. To achieve optimal results, I recommend incorporating bridging support into the print job and printing at a moderate speed to prevent water from leaking due to poor printing quality. The bowl is designed to accommodate a standard 600ml spring water bottle. Before use, I carefully remove the tiny finger grip lines on the bottle cap by running it through a file. To create a hole in the cap, I first screw it onto the bottle for stability and then drill progressively larger holes (3mm, 4mm, 5mm, 6mm) until I reach the desired size - approximately 12mm - allowing air to bubble into the bottle and facilitate water flow. To utilize this system, I locate a pair of wires with the best fit within my dog's cage, as wire spacing can vary. From inside the cage, I clip the bowl between these wires and fill the bottle with water. Holding my finger over the hole in the cap, I quickly invert the bottle and insert it into the bowl with a clockwise twist, taking care not to spill any water. By employing this design, pet owners can ensure their pets always have access to fresh drinking water - a vital aspect of maintaining their overall health and well-being.