Dog house - doghouse

thingiverse

Basic doghouse - constructed from two fundamental components. This particular model is quite expansive, as the canine occupant was of considerable size. To print the bottom section, a minor amount of support is required solely for the entrance area. However, if high-quality PLA material with adequate cooling is utilized, I believe even minimal support may be unnecessary. I did employ support structures during printing, but ultimately found them to be non-essential. For the roof portion, only auxiliary support is necessary along the outer rim - the roof rests on the main structure with a 2mm expansion gap. Consequently, some support is required around this area. Nevertheless, no additional support is needed to maintain the roof's stability; it should print successfully without any further assistance. In my opinion, the roof design could be slightly reworked to eliminate the need for support altogether. Nevertheless, as I have already printed the existing model, there is no pressing reason to make any modifications. The source files are included in the attachment - Cubify Invent format - allowing you to rename or customize the design as needed, or even add new elements of your own choice. To recap, minimal support is only required for a 2mm perimeter around the entrance area.