Dog Feeding Sliders

thingiverse

I made this so that I remember to feed my dog three meals a day. I printed it out, assembled it, and stuck it on the top of my dog's food container, and each time it's fed, we slide the corresponding meal's slider over. I printed the base in blue, and the top and bottom in red ("red is fed"). You will need: - 1 Base - 3 Bottom - 3 Top - 6 Tacks/Wire Nails The holes in the sliders are 1.5mm in diameter, so any tacks or nails that are about that size will fit. Place the bottom below the base in one of the three cut-out sections, and then place the top on top of the base, with the two holes lining up. Then push or hammer the nails through, and clip the ends so it doesn't stick through to the other side. Tinkercad Model: https://www.tinkercad.com/things/66g6DNs7tjO