Doctor Strange - Eye of Agamotto (remix)

thingiverse

This is a remix from thing #1929165. I added a housing for a battery, switch, and/or microcontroller unit, as well as a housing for an RGB light-emitting diode. The 500mAh lithium polymer 3.7V battery, miniature slide single-pole single-throw switch, and 10mm RGB LED were used. The only caveat to the original one is that you cannot open and close the eye since the battery holder covers it. I simply opened the eye so that the led light will be visible. The STL file description: switchcover.stl is a housing for the battery, mini switch, and electronics. ledhole.stl is a housing for the 10mm RGB LED (1st lighting option). NeoHolderv2.stl is a housing for the RGB NeoPixel (2nd lighting option). Hole Drill: You will have to drill a hole in the original part (shown above) for the LED wires or NeoPixel wires. Second Option electronics: This can also hold an Adafruit trinket or Adafruit Flora and single RGB NeoPixel [Adafruit part#1260]. Future Remix (not shown): I did a third option (with modification not shown) by adding NewoPixel Jewel 7 [Adafruit Part#2226] with Gemma. I will need to add a recharge board for this future option. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: No Supports: No Resolution: .2 Infill: 20% Notes: The parts from the original require supports, but the remixed added parts (RGB LED housing, RGB NeoPixel housing, and housing for switch and battery) do not require any supports. For the original parts I used FFCP(2016), and for the remixed added parts I used a UM2. Post-Printing Post: UM2 Print bed From top counter-clockwise: RGB NeoPixel Holder (2nd lighting option) RGB LED Holder (1st lighting option) Battery/Switch and/or MCU housing If you are using RGB LED only, battery and switch are needed. MCU is needed if you use the RGB NeoPixel option.