Dockteck DD0003 Steam Deck Dock Enclosure

prusaprinters

<p>Converts the Dockteck DD0003 USB-C Hub into a fully enclosed Steam Deck Dock. Ran out of good new filament so I used old filament in the pictures (sorry).</p><p>Tolerances were made for printing at 0.3mm layer height.</p><p><strong>IMPORTANT! </strong>Print the top piece as mesh, if the hubs are fully enclosed they will 100% overheat! <i>(top layers: 0, bottom layers: 0, wall line count: 8, infill pattern: lines, infill density: 20% or less)&nbsp;</i></p><p><i>Base can be printed similarly, your choice (mine is mesh)</i></p><p><strong>additional parts needed</strong></p><p>M2 6mm screws (pan head or similar) <a href="https://www.amazon.com/dp/B00F33TFRS">https://www.amazon.com/dp/B00F33TFRS</a></p><p>Total Part Cost ~<strong>$7</strong></p><p><strong>Optional Parts</strong></p><p>USB-C 3.1 Right Angle Adapter/Extender <a href="https://www.amazon.com/dp/B08CDGHQWF">https://www.amazon.com/dp/B08CDGHQWF</a></p><p>CAT6 Right Angle Ethernet Cable <a href="https://www.amazon.com/dp/B01FHC0H7G">https://www.amazon.com/dp/B01FHC0H7G</a></p><p>Total Part Cost ~<strong>$16</strong></p><p><strong>Make sure to have supports enable if your bridge settings are not good!</strong></p><p><i>my print settings</i></p><p><a href="https://imgur.com/a/CjuzrJU"><i>https://imgur.com/a/CjuzrJU</i></a></p><p><strong>To Purchase One</strong></p><p>Head over here, <a href="https://mogindustries.com">https://mogindustries.com</a> or here https://www.etsy.com/shop/MOGindustries</p>