DnD Miniature Flight Stand (Parametric and Customizable)

thingiverse

Saw some very cool flight stands on Dimension 20's Neverafter and wanted to create my own. I have included some pre-generated files that I used with the following parts: - [Craftsman Telescoping Tool](https://amzn.to/3XKopfH) - A stack of steel washers (the heavier the better) - For medium creatures, e.g. 1" or 25mm base, I recommend using M10 washers or [3/8" x 1" washers](https://amzn.to/3PBpZ1d) - For large creatures, e.g. 2" or 50mm base, I recommend using [M16 x 50mm washers](https://amzn.to/3Pu48ZA) Assembly instructions: 1. Unscrew the bottom of the telescoping tool off and remove the pocket clip, keep the screw removed for step 5 below 2. Push the telescoping tool through the hole in the printed stack cover, it should fit tightly if you are using my pre-generated files. The side with the magnet should be on the closed side of the cover. 3. Insert the stack of washers into the printed stack cover. 4. Place the stack cap on the end of the stack of washers with the screw inset pointed out. 5. Re-use the screw that held the pocket clip to screw the stack cap onto the bottom of the telescoping tool. This may require a good amount of force to force the screw into the inset hole as it is quite snug and there is not a lot of extra threading. 6. If you like you can glue the cap on with a couple drops of super glue. Optional step: Though I have not found it necessary, the gridded bases have enough extra space to glue in a small circular magnet like [these](https://amzn.to/3NTmgLk). You may also want to glue the magnets onto the base of your miniatures to ensure they stay on the flight stand, or [stick tack works great](https://amzn.to/3PFNOoN).