DND Magnet

prusaprinters

<p>Following the inspiration from my Marvel Magnets (https://www.printables.com/model/202156-marvel-magnets) I wanted to do one for DND too.</p><p>I'll spare you the blah blah back story, but it's the same as the one I wrote over there.<br>I made the ones I did since i had the appropriate colors, feel free to experiment with other ones too. &nbsp;I uploaded a blank base with the magnet holes, so go nuts.</p><p>I used this object on Thingiverse as my top of magnet bits:</p><p>https://www.thingiverse.com/thing:3325895</p><p>I needed to print mine with rafts, since the small magnet hole circles just would not stick to my bed. &nbsp; YMMV of course. &nbsp;</p><p>I used 5x3mm magnets from Amazon (https://www.amazon.com/gp/product/B08M3H4VP5/) and after some experimentation made the holes 5.2 mm for a bit of tolerance. &nbsp;They were a good friction fit and I tapped them in with a hammer and nail set to be sure.</p><p>The color swap was at layer 21 without a raft and 25 with one (using Cura standard raft settings).</p><p>It doesn't need supports.</p><p>Enjoy!</p>