DnD Dice Box / Tracker

prusaprinters

<h3>Introduction:</h3><p>The dice case is fully 3D printed, no supports are needed. You need to glue the D&amp;D letters in and a few letters in the inside and the rollsurface as well. The reason is only to achieve some nice multicoloured effects.</p><h3>Important:</h3><p>I had big trouble to print the upper and lower box piece. Either I had warping or after the finished print it was bend into the opposite direction after releasing it form the bed. The way I solved this issue:</p><ul><li>use a glass bed clamped to the heat bed</li><li>use (a sh*t load of) adhesive spray&nbsp;</li><li>bed temperature 30° to minimize the temperature difference</li></ul><p>Afterwards let it fully cool down. To get the print off will not be easy, but if you manage to do it carefully it is worth the trouble.</p><h3>Some further notes:</h3><p>How many pieces you need of each file is stated in the file name.</p><p>You should print the following two coloured by switching the filament:</p><ul><li>Labeling</li><li>Upper_Box_Labels</li><li>Rollsurface</li></ul><p>It is intended to not glue the lables on the bottom in. You may customize them according to what you play and what need in the current situation.</p><p>You can print the Upper_Box without supports, the DnD letters can be done using bridging.</p><h5>Last but not least, if you like the design, please consider a tip, I need some beers after this ;-)</h5>