Dna 200/250 Power Supply Mod Pod

thingiverse

This model is part of several vape-related models I'm releasing from my data vaults, most being a few years old and some mostly usable as assets. Check my profile for other designs that may be of interest in the coming days. If you appreciate the designs I upload, please consider leaving a tip via Thingiverse. A lot of time goes into some of my designs, and even more time goes into the designs that never quite made it to Thingiverse. This one is actually pretty awesome, as the idea was to make a DNA200/250 mod as small as possible. The best way to make it smaller is to relocate the power source. In this case, I have a 12V ATX power supply that sends 12V to up to four mods via quick disconnect connections. Parts List: 1x DNA 200/250 1x Speakon quick connector 1x 510 connection Miscellaneous wire and wire shielding Print is incredibly straightforward here. The face plate prints flat side down, while the rear pod prints vertically. The 510 connection is located close to the chip when wiring; just bend the group tab on the 510 ninety degrees and solder it directly to the chip, then run a positive wire like normal. Wire in the Speakon connector to the power input and you have two wire channels to run the main power wire out of, depending on whether you want the mod to sit flat or not. The two halves just slide together for a nice friction fit.